ICT Sample Site
ICT200DB-12IRC Distribution Panel
IP Address: 209.121.192.82
Firmware: v3.08

Output Setup

Select an Output to edit   (Click "Save Settings" when finished)
+12VDC Bus-48VDC Bus
1A: Radio 11B: Repeater A
2A: Radio 22B: Repeater B
3A: Radio 33B: Repeater C
4A: Radio 44B: Repeater D
5A: Radio 55B: RF Amplifier
6A: Radio 66B: Auxilary

Output Settings
Output Label:
Output State after Panel Reset:
Ignore Circuit Breaker Status:
Enable Power Cycling:

If Power Cycling is enabled, "Sequence/Cycle Delay" must be set on the Device Setup page.

Output Load-Shedding
Enable Load-Shedding:
Load-Shedding Threshold: VDC
Load-Shedding Auto Recovery:
Auto Recovery Threshold: VDC

If enabled, Load-Shedding will disable this output if the system voltage drops below the threshold for at least 30 seconds.

Output Over-Current Alarm
Over-Current Threshold:> A

When an Over-Current condition occurs on this Output,
Activate Alarm Form C Contact:
Send E-mail:
Disable this Output:

This alarm will have no effect if the threshold is set to 0 Amps.

Output Under-Current Alarm
Under-Current Threshold:< A

When an Under-Current condition occurs on this Output,
Activate Alarm Form C Contact:
Send E-mail:

This alarm will have no effect if the threshold is set to 0 Amps.